ERICSSON RBS 6601 PDF
WCDMA RAN Systems and Site Introduction. RBS components. WCDMA RBS Maintenance. 2. Customer Product Information (CPI) and. TXO Systems has the ERICSSON RBS RRUS 12 B3 in stock, along with a wide range of used and refurbished telecommunications equipment from all. Ericsson shall have no liability for any error or damage of any kind resulting from The support system for the RBS main unit is available in two variants.
|Published (Last):||20 July 2004|
|PDF File Size:||9.67 Mb|
|ePub File Size:||4.87 Mb|
|Price:||Free* [*Free Regsitration Required]|
Slot 2 is the upper position in the main unit. The on-site transmission system depends on the used DU. Skip to main content.
Cincinnati, Ohio, United States. Have one to sell?
Ericsson RBS 6601 LTE Indoor Main Unit Remote Base Station 1/bfl 901 009/4
This document describes how to install the RBS on site and how to connect it to external interfaces. To connect the RBS to the twisted-pair cable: Strip off 12 mm of each wire using the cable shield cutter. To connect the optical cable to the bidirectional transceiver SFP, do the following: All our products are screened and re-packed in new, unbranded ESD packaging, ensuring they reach you in the best possible condition.
Do not install or modify AC or DC powered equipment unless you are a qualified and authorized electrician. See also the following documents for verifying other units installation: The cable connections depend on the transmission alternative chosen for the specific site.
Leave the protective cap on the inactive fiber marked with yellow. You are free erjcsson manage this via your browser settings at any time.
Figure 3 shows the grounding for the support system variant 1, and Figure 4 for the support system variant 2.
The ericcsson indicated in the figures can vary. To install a TCU in slot 2 in the main unit: Learn More – opens in a new window or tab. Click here to sign up. Switch off or disconnect any external battery back-up. The main unit has already been verified at the factory.
The DC power supply must be equipped with an external fuse or circuit breaker. Check that each cable is as straight as possible and make any necessary adjustments. Connect the longer Enclosure Control EC bus cable as follows: If a multi—strand wire is used, the end of the wire should be tinned or provided with a wire end ferrule. Support system variant 2 supports all DUW versions. Detailed information is found in Hardware Maintenance Instructions. Insert the cables into the specified ports on the main unit according to Site Installation Documentation.
If the distance is less than 50 mm, the brackets must be adjusted, see Step 2. Add to cart – Best Offer: Therefore, install the main unit at a convenient working height and route all cables with necessary extra length to allow ericssln removal of the main unit without disconnecting the cables.
The cables are optical and must be handled with care. Ericsspn international shipping and import charges 6061 paid in part to Pitney Bowes Inc.
Ericsson RBS LTE Indoor Main Unit Remote Base Station 1/bfl /4 | eBay
A DBA is placed in the same inch rack that the main unit is placed in, or in another rack. Connect the DC power cable to the power supply terminals. If it has been damaged, make an immediate complaint to the transport company.
The instructions in this document describe the installation of the following hardware: Each alarm signal consist of one pair of wire connections. Carefully observe the polarity of the cable installation. Remove the protective cap from the active fiber marked with white.
Contact us Add to quote. This means the item has been ericssob, cleaned, and repaired to full working order and is in excellent condition.
Place the main unit in the rack and tighten the rack screws on the brackets according to the rack supplier’s specification.